WARNING: To reduce the risk of electric shock or damage to the equipment: Install the server in the rackīefore installing a server, be sure that you understand the following warnings and cautions.

For server-specific information, see the server user guide on the Hewlett Packard Enterprise website. For options installation information, see the documentation that ships with the option. Install any hardware options before initializing the server. Off = One or more of the following conditions exists: Solid blue = Identification is activated.įlashing blue = System is being managed remotely. *The slot 3 PCIe 3 riser is optional and requires a second processor before installation. †To identify components in a degraded or critical state, see the Systems Insight Display LEDs, check iLO/BIOS logs, and reference the server troubleshooting guide. †If the health LED indicates a degraded or critical state, review the system IML or use iLO to review the system health status. **Facility power is not present, power cord is not attached, no power supplies are installed, power supply failure has occurred, or the power button cable is disconnected. For more information, see 'Power fault LEDs.' *When all four LEDs described in this table flash simultaneously, a power fault has occurred.

8 Hz/cycle per sec = iLO manual reboot sequence in progress.

4 Hz/cycle per sec = iLO manual reboot sequence initiated.

1 Hz/cycle per sec = Remote management or firmware upgrade in progress.

Power On/Standby button and system power LED*įlashing green (1 Hz/cycle per sec) = Performing power on sequenceįlashing green (1 Hz/cycle per sec) = iLO is rebooting.įlashing red (1 Hz/cycle per sec) = System critical†įlashing green (1 Hz/cycle per sec) = Network active

Verify operating system support-For information about operating systems supported by ProLiant servers, see the operating system support matrices.įor more pre-installation information, see the HPE ProLiant D元60 Gen9 Server User Guide on the Hewlett Packard Enterprise website.

Unpack the server shipping carton, and locate the materials and documentation necessary for installing the server.

Select an installation site that meets the detailed installation site requirements described in the server user guide.

For safety, environmental, and regulatory information, see Safety and Compliance Information for Server, Storage, Power, Networking, and Rack Products.

Setup Overview HPE ProLiant D元60 Gen9 Server

Hp smart array controller launch setup